This is the trunk of a BMW  M3 convertable.  The Subwoofers are 10 inch Diamond  D6 dual  4 ohm voice coil, mounted inverted in custom made fiberglass cabinets, Angled so they would fit in the trunk without interfierince to the convertable top.  The center rack is two Memphis 500 watt amps in a custom rack, one amp per subwoofer.   The photo in the middle, shows the amp rack without it's cover on.  The rack was designed and built by Dan Bowen. The rack is covered in MicroFiber to match the interior.  The system is hooked up to the factory radio. Work by: Dan Bowen, Steve creamer, Joe  Kozel & Jon Becker.

  The seats, amp rack & sub cabinet covering was performed by Willow Grove Auto Top in Willow Grove, Pa.   Labor by Will Winder.  (Thanks Will , good job!)

The photos at the bottom show an AMG Mercedes G  55 Wagon.  We installed navigation,video, amplifiers, custom subwoofer cabinets, rear deck to hide 2nd batery, 2 amps, crossovers for door speakers, navigation unit, battery isolaters, fuses and relays.   The truck ROCKED!.

It took 7 days to complete.  Alpine radio & navigation, Diamond seperates in doors, Soundstream and Memphis amps, Alpine Subs and a lot of fiberglass and MDF.

Work by Dan Bowen, Steve Creamer, Joe Kozel & Jon Becker.

Photos below are of a Pt Cruiser owned by Dave Brown.  Dan Bowen & Steve Creamer installed 7 video monitors in the Pt Cruiser.  1 overhead, 1 in each "Lambo style" door (angled so that they are level when the door is open), 2 headrest monitors, one lower console monitor, and one monitor on the rear hatch, installed into the housing of the 3rd brake light. When you open the trunk the monitor is at the top of the car.  Look closely at the photos and you will see all the monitors are on.  this job took 3 days of uniterupted work.

The rear of the car has a custom built subwoofer box and amp rack. The box has 4 Memphis 15-PR124D subs, with one sub inverted, and 2 memphis amps, a 16MCD1000 for the subs, and a 16MCA2004 for the mids and highs.   The box & amp rack took 3 weeks to complete. the box is 4 seperate enclosures, and hidden compartment for the Aluma Pro 5 farad carbon capacitor with distribution block.

NEW information.....since we wrote this page, there have been many more changes to Dave Browns PT Cruiser.  His PT is the only vehicle in the North American Hemisphere with a 10.5 inch monitor built into the  steering wheel. Steve Creamer and Dan Bowen, with a little help form Jon Becker, worked tirelessly for 3 weeks to make it happen.  This feature has made the PT a Show stopper and Trophie winner every where it goes. Dave Brown has won over 28 trophies for first place or best of show....and a few more are on the way !

Please see the slide show of the PT under construction. (again !)

We promise you that after the winter teardown and rebuild, Dave's PT will be BIGGER & LOUDER then before, as for video....some big surprises are comming.

Three pieces of wood are laid on floor to lift box to runk level. Notice the tape on sides of interior to mark out placement of box.

This is the basic form of the box,all three subs are one cabinet, 3/4 inch MDFheld with nails and heavy glue just for MDF.